Drilling from 6 parties . There are 2 drilling groups installed on the machine: 8 - horizontal spindles, 21 - vertical spindles (12 - from above, 9 - from below). As standard, 2 milling units for 5.5 kW and 3.5 W are installed.

2 milling spindles 5.5 kW and 3.5 kW , 18000 rpm (top and bottom). The upper milling spindle, due to its increased power, has the ability to work with various tools and carry out various operations - milling under the LAMELLO coupler, side milling and grooving .

A special CNC unit has the ability to carry out sawing, drilling and milling operations (for invisible fittings, handles, hinges, etc.).

The top milling spindle is equipped with a 5-station linear tool change , which saves time when switching from one type of processing to another.

Grooving unit with a saw (disk diameter 120 mm).

Two automatic clamps will allow you to securely fix the workpiece with a length of 70 mm. up to 2800 mm and perform fewer interceptions during drilling, which significantly increases the speed of the work cycle compared to machines with a single grip. The maximum speed has been increased to 140 m/min .

The top milling spindle is equipped with a powerful vertical clamp with two pressure plates . Improves milling accuracy and prevents damage to the workpiece.

Batch drilling mode - processing of two parts at the same time with a mirror map.

CAD/CAM control panel, with the ability to read bar codes, which allows you to increase the productivity of the machine.

A barcode scanner is included in the basic equipment of the machine.

Ability to work with all popular programs for optimizing drilling maps and printing labels.

The machine bed was developed taking into account CAD programs, where the maximum allowable loads and requirements for the machine design were calculated and simulated. The welded frame is tempered to relieve all internal stresses in the material, then processing takes place on a five-axis metalworking machine, where all platforms and holes for mounting components and assemblies are milled.

The machine in the basic configuration has a conveyor for removing chips and small residues of workpieces.

Easy movement of parts on the table occurs due to the air flow supplied by a special electric fan through the holes in the upper part of the table, thereby eliminating the possible appearance of scratches on the lower surface of the part.

Mobile plates in the drilling area allow for through milling.

Protecting the operator from injury.

Finished parts exit area with cross conveyor, equipped with workpiece detection sensor.

The minimum workpiece size is 70x35 mm , which allows for the addition of small-sized parts.

The machine uses high-precision INVT servo drives for superior precision and high productivity.

Sealed dust and moisture resistant cabinet with electronic components from the world's leading manufacturers is removed from the processing area, which prolongs the service life of electrical components and provides ease of maintenance.